MANUALS · HEATER, AIR CONDITIONER AND VENTILATION [55] · страница 106 из 118 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

LEVER POSITION SWITCH <4056-AIT, 4M4O-A/T>

REMOVAL AND INSTALLATION

Pre-removal and Post-installation

Operation
Removal and Installation of
Intercooler
(Refer t0 GROUP 15Intercooler )

Lever position switch

INSPECTIONESSHCAP

INSPECTION OF LEVER POSITION SWITCH

(1)Connectcircuit testerasshowninthe diagram,and
checkthatthereis continuityinthesection0.3mm
(0.012 in ) from the full length (full stroke), and that there
is no continuity for the remainder of the stroke (5.0 mm
[0.197 in:J).

(2) If there isa defect, replace the component.

SERVICE POINT OF INSTALLATIONESSHDAF INSTALLATION OF LEVER POSITION SWITCH

Check that the idle speed is at the standard value, and
adjust it if necessary_

Standard value:750 + 100 r/min

Adjust the accelerator cable

Depresstheaccelerator pedal fullyto fullyopenthe
throttle lever of the fuel injection pump_

Caution

Whenfullyopening the throttle lever of the fuel in-
jectionpump,alwaysopenbytheaccelerator
pedal, not from the injection pump side:

Adjust thestrokeofthe leverpositionswitchrodby
movingtheleverpositionswitchSOthattherodis
pushed down4 +mm (0.16 * 0.04 in) from the free
position.

Оригинальная страница руководства