MANUALS · HEATER, AIR CONDITIONER AND VENTILATION [55] · страница 114 из 118 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF INSTALLATION 4.INSTALLATION OF COMPRESSOR

If a new compressor is installed, first adjust the amount of oil
accordingtotheprocedures describedbelow,andthen
install the compressor.

(1) Measure the amount [X cm?cu.in:)] of oil within the
removed compressor.

(2) Wipeaway(from the new compressor) the amount of oil
calculated according to the following formula, and then
install the new compressor:

Amount of oil in new compressor:

80 cm? (4.9 cu.in:)*1
~Xcm? (X cu.in:) = Y cm?cu.in:)
150 cm? (9.2 cuin.)*2

NOTE

(1)Compressor for single A/C

(2)Compressor for dual A/C

(3)cm?cu.in ) indicates the amount of oil in the
refrigerant line, the condenser, the cooling unit; etc

(4) If replacing any of the following parts at the same
time as the compressor, subtract the specified amount
of oil for each of the parts from Y cm?cU:in:)and
thenremovethisamountofoilfromthenew
compressor.

Quantity:

<Vehicles using R-12 refrigerant >

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Evaporator	60 cm? (3.6 cu.in.)
Condensor	30 cma (1.8 cu.in:]
Suction hose	10 cm? (0.6 cu.in:
Receiver	(0.6 cu.in. 10 cm?

<Vehicles using R-134a refrigerant >

Compressor for single A/C

Evaporator40 cm? (2.4 cu.in:"
Condenser40 cm? (2.4 cu.in_
Suction hose10cm?(0.6 cu.in:
Receiver10 cm? (0.6 cu.in )
Compressor for dual A/C
Evaporator60cm?(3.6 cu.in:"
Condenser30 cm? (1.8 cu.in:
Suction hose10 cm? (0.6 cu.in
Receiver10 cm? (0.6 cU.in:S
(5)Installthecompressorwiththecompressor
mountingboltsattachedtothecompressor
<4056, 4M4O>

Оригинальная страница руководства