COMPRESSOR AND TENSION PULLEY

MANUALS · HEATER, AIR CONDITIONER AND VENTILATION [55] · страница 117 из 118 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

REMOVAL OF ROTOR ASSEMBLY

Usingplastichammer, lightlytaptherotoroffthe
shaft.

8REMOVAL OF THROUGH BOLT

Removethethroughboltafterfirst securingtherear
housing of the compressor by placing it ina vise

Caution

If the through bolt is removed without first doing SO,
therearhousing will becomeuncoupledandcom-
pressor oil will escape:

10. REMOVAL OF FELT

Usingscrewdriver,removethefelt fromthefront
housing:

13. REMOVAL OF SHAFT SEAL

Usingscrewdriver,removetheshaftseal fromthe
front housing:

Проверка

ESSLDAE

Check the surface of the clutch hub for scoring or bluing_
Check the surface of the rotor for scoring or bluing
Checkthe sealingsurfacesforcracks,scratches and
deformation,

Checkthe front housing forcracksorscoringonthe
sealing surfaces_
Check the compressor shaft for scoring

SERVICE POINTS OF REASSEMBLYESSLEAJ

13. INSTALLATION OF SHAFT SEAL

(1) Lubricatetheshaftsealwith specifiedcompressor
oil:.

Mitsubishi Motors Corporation

July 1993

Specified compressor oil:
<VehiclesusingR-12 refrigerant >

DENSO OIL 6
ND-OIL 8

(2) Set the shaftsealtothefronthousingSOthatthe
projection side of the center ring is at the shaft seal side
(3) Using a 21mm (0.83in:)socket, install the shaft seal.
PWJE9086-DREVISED

Оригинальная страница руководства