1989-Montero · brakes · страница 11 из 38 · Открыть оригинал PDF ↗
TEST WITH A SIMPLE TESTER
Prior to the test, remove the check valve from the brake
booster and check the check valve for operation. (Refer to P.5-
12.)
With the check valve removed, make connections as shown,
using another check valve (MB238892, etc.), vacuum gauge,
pressure gauges and foot pressure gauge, bleed the pressure
gauges, and proceed as follows:
Test 1 - Air-tightness Test with No Load
(1) Start the engine.
(2) Stop the engine when the vacuum gauge reaches approxi-
mately 68 kPa (20.1 in.Hg).
After stopping the engine, wait approximately 15 seconds,
and then measure the decrease in vacuum.
Standard value : 3.3 kPa (0.97 in.Hg) or less
(3) If the vacuum decrease exceeds the standard value, check
the vacuum hoses, and the brake booster, and make any
necessary corrections.
Test 2 - Air-tightness Test Under Load
(1) Start the engine.
(2) Depress the brake pedal at a force of .approximately 200 N
(44 Ibs.).
Stop the engine when the vacuum gauge reaches approxi-
mately 68 kPa (20.1 in.Hg).
(3) After stopping the engine, wait approximately 15 seconds,
and then measure the decrease in vacuum.
Standard value : 3.3 kPa (0.97 in.Hg) or less
(4) If the vacuum decrease exceeds the standard value, check
the check valve, the vacuum hoses, and the brake
booster, and make any necessary corrections.
Test 3 - Boosting Function Test
Start the engine.
Depress the brake pedal when the vacuum gauge reaches
[:I
approximately 68 kPa (20.1 in.Hg).
(3) Check to be sure that the brake fluid pressure is the
standard value when the brake pedal is depressed at a
foot force of 100 N (22 Ibs.) and 300 N (66 Ibs.)
Standard value :
At 100 N (22 Ibs.) foot force
2.45-3.92 MPa (356-569 psi)
At 300 N (66 Ibs.) foot force
9.81-12.26 MPa (1,422-1,778 psi)
(4) If the output fluid pressure agrees with the standard value,
the brake booster is functioning properly.

