1989-Montero · brakes · страница 21 из 38 · Открыть оригинал PDF ↗
(I) Measure the dimension (6) from the edge of the
master cylinder to the piston.
NOTE
Obtain the dimension (B) by first placing a straight
scale against the edge of the master cylinder, and then
measuring and subtracting the thickness of the straight
scale.
(2) Obtain the dimension (C) from the master cylinder’s
brake booster installation surface to the edge.
(3) Measure the dimension (D) from the brake booster’s
master cylinder installation surface to the end of the
push rod.
NOTE
Obtain the dimension (D) by first placing a straight
scale against the edge of the brake booster, and then
measuring and subtracting the thickness of the straight
scale.
(4) Obtain the clearance (A) between the brake booster
push rod and the primary piston. from the values
obtained in (I), (2) and (3) previously.
Standardvalue : 0.1-0.5 mm (.0&l-.020 in.)
.(5) If the clearance is not within the standard value range,
adjust by changing the push rod length by turning the
screw of the push rod.
Caution
Improper clearance may cause excessive brake drag.
6. APPLICATION OF BRAKE FLUID TO DIAPHRAGM /5. RESERVOIR CAP
Apply the specified brake fluid to the contact surface
shown in the illustration.
Specified brake fluid: DOT 3
Оригинальная страница руководства
