1989-Montero · brakes · страница 20 из 38 · Открыть оригинал PDF ↗
13. REMOVAL OF PISTON STOPPER RING
Remove the piston stopper ring while depressing the
piston.
14. REMOVAL OF PRIMARY PISTON ASSEMBLY
Caution
Do not disassemble the primary piston assembly.
15. REMOVAL OF SECONDARY PISTON ASSEMBLY
NOTE
If the secondary piston is difficult to remove, apply
compressed air gradually from the secondary side outlet
port of the master cylinder, and then remove the secon-
dary piston from the cylinder.
Caution
Do not disassemble the secondary piston assembly.
Проверка
NcnIcAA
@ Check the inner surface of master cylinder body for rust or
scars.
e Check the primary and secondary pistons for rust, scour-
ing, wear, damage or deterioration.
I) Check the diaphragm for cracks or deterioration.
No!mA~
SERVICE POINTS OF INSTALLATION No!mA~
15. APPLICATION OF BRAKE FLUID TO SECONDARY PI-
STON ASSEMBLY/lB. PRIMARY PISTON ASSEMBLY
Apply the specified brake fluid sufficiently to the inner
surface of the master cylinder body and to the entire
periphery of the secondary and primary pistons.
Specified brake fluid: DOT 3
l ADJUSTMENT OF CLEARANCE BETWEEN BRAKE
BOOSTER PUSH ROD AND PRIMARY PISTON
Check and adjust the clearance (A) between the brake
booster push rod and the primary piston by following the
steps below.
Оригинальная страница руководства
