1989-Montero · brakes · страница 31 из 38 · Открыть оригинал PDF ↗
(2) When using the bolts.
Screw the bolts (M8 x 1.25) in the threaded holes
provided in the drum flange surface.
INSPECTION CHECKING BRAKE LINING THICKNESS
No6”cA.J
(I) Measure the wear of the brake lining at the place worn the
most.
Limit : 1.0 mm (.039 in.)
(2) If the thickness of the brake lining is the limit value or
below, or if there is noticeable abnormal wear, replace the
shoe assembly.
NOTE
In order to prevent one-sided braking, replace both the left
and right shoe assemblies as a set.
CHECKING BRAKE DRUM INSIDE DIAMETER
Refer to P.5-16.
CHECKING BRAKE LINING AND BRAKE DRUM CONTACT
Refer to P.516.
SERVICE POINTS OF INSTALLATION
NOSUDAH
8. APPLlCATlON OF GREASE TO SHOE HOLD-DOWN PIN
Apply the specified sealant to the shoe hold-down pin
inserting portion of the backing plate.
Specified sealant: 3M Sealant Part No. 8834
or equivalent
7. APPLICATION OF SEALANT TO SHOE AND LEVER
ASSEMBLY/G. SHOE AND UNING ASSEMBLY
Apply the specified grease to the contacting surfaces of
the shoes and backing plate, anchor plate and wheel
cylinder piston ends.
Specified grease: Brake grease SAE J310, NLGI No. 1
Оригинальная страница руководства
