Pajero II Workshop Manual 1998 Supplement · FUEL · страница 16 из 104 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
13-16 FUEL SYSTEM <6G72-SOHC 24 Valve Engine, 6G74-SOHC 24 Valve Enginez _ Troubleshooting
READ OUT OF MALFUNCTION CODE
Precautions tor Operation
(1)When battery voltage is Iow,no detection of failure is
possibleBe sure to check thebattery for voltage and
other conditions before starting the test.
(2) Diagnosis item is erased if the battery or the engine
control unit connector is disconnected. Do not disconnect
the battery before the diagnosis result is completely read.
(3)Be sure to connect or disconnect the MUT-II with the
ignition switch turned off_
WHEN USING THE MUT-II
Caution
Turn off the ignition switchbeforedisconnecting or
connecting the MUT-II:
Connect the MUT-II to the diagnosis connector:
Turn the ignition switch to ON:
Take a reading of the diagnosis output:
Repair the problem location, referring to the diagnosis
chart
5)After turning the ignition switch once to OFF; turn it back
to ON
6)Erase the diagnosis code.
Recheck to be sure that the condition is normal.
WHEN USING THE ENGINE WARNING LAMP (CHECK ENGINE LAMP)
Use the special tool (diagnosis code check harness) to
earth the diagnosis test mode control terminal (terminal
0) of the diagnosis control terminal (16 pin).
Turn the ignition switch to ON_
Takereading ofdiagnosis output according to how
often the engine warning lamp flashes.
(4)Repair the problem location, referring to the diagnostic
chart:
(5)Erase the diagnostic code by the tollowing procedure:
Turn the ignition switch to OFF
After removing the battery cable from the battery
terminals for 10 seconds or more, reconnect the
cable
Warm up the engine and let it idle for approx:15
minutes
Turn the ignition switch to ON and take a reading of
the diagnostic output to check ifa normal code is
output.
Оригинальная страница руководства
