Pajero II Workshop Manual 1998 Supplement · FUEL · страница 50 из 104 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SENSOR INSPECTION

Disconnect the throttle position sensor connector:

(2) Measure resistance between terminal(sensor earth)
and terminal(sensor power) .
Standard value: 3.56.5 ko

(3) Connect & pointer type ohmmeter between terminal
(sensor earth) and terminal 0 (sensor output)

(4)Operate the throttle valve slowly from the idle position to
the full open position and check that the resistance
changes smoothly in proportion with the throttle valve
opening angle.

(5) If the resistance is out of specification, or fails to change
smoothly, replace the throttle position sensor:
TPS installation torque: 2.0 Nm

For the idle position switch and throttle position sensor
adjusting procedure , refer to P.13-21_

Оригинальная страница руководства