Pajero II Workshop Manual 1998 Supplement · FUEL · страница 77 из 104 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SENSOR INSPECTION <OXYGEN SENSOR (FRONT)>
Disconnect the oxygen sensor connector:
Check that there is continuity [4.58.02 at 20*C]
between oxygen sensor connector terminaland
terminal

(3)If there is no continuity, replace the oxygen sensor:

(4)Warm the engine until the engine coolant temperature
reaches 80'C or more

5)Use the jumper leads to connect the oxygen sensor
terminal 0 (connect (+) terminal) and terminal
(connect (~) terminal) to the batteryand (~) terminals
respectively:

Caution

Be caretul when connecting the jumper leads, as
connecting the terminals incorrectly will damage the
oxygen sensor:

(6) Connectdigital-type voltmeter to terminaland
terminal @-

While repeatedly racing the engine, measure the oxygen
sensor output voltage_

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Engine	Oxygen sensor output voltage	Notes
When racing the engine	0.6_ 1.0 V	When the airlfuel mix- ture ratio is enriched by racing the engine repeatedly, a normal oxygen sensor will voltageof output a 0.6-1.0v.

NOTE

For removal and installation of the oxygen sensor; refer to
GROUP 15Exhaust PipeMain Muffler and Catalytic
Converter:

Оригинальная страница руководства