Pajero II Workshop Manual 1998 Supplement · FUEL · страница 90 из 104 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
13-90 FUEL SYSTEM <6G72-SOHC 24Valve Engine, 6G74-SOHC 24Valve Enginez _
INSPECTION
Using MUT-II
<Spark Advance>
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No_ | Data display | Check condition | Engine state | Standard value |
|---|---|---|---|---|---|
| Data reading | 44 | Ignition advance | Engine: Warming up Timing lamp: Set (set timing lamp to check actual ignition timing) | 700 rlmin (Idle) 2,500 rlmin | 7 _ 230 BTDC 27 470 BTDC |
<Standard Ignition Timing?
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Function | Item No | Drive | Check condition | Normal condition |
|---|---|---|---|---|
| Actuator test | 17 | Set to ignition timing adjustment mode | Engine: idling Timing lamp: set | 5" BTDC + 39 |
Wave Pattern Inspection Using an Analyzer
Ignition coil primary signal
Refer to GROUP 16Ignition System:
Power transistor control signal.
<Measurement method>
(1) Disconnect the power transistor connector; and connect
the special tool (test harness: MB991348) in between. (AlI
terminals should be connected: )
(2) Connect the analyzer special patterns pickup to the
connector terminals(No. 3No. 6) ,(No: 2No. 5)
and(No:No. 4) in that order:
Alternative method (when test harness is not available)
Connect the analyzer special patterns pickup to engine control
unit terminals (10), (11), (23) and (31) for the ignition power
transistor:
Оригинальная страница руководства
