MANUALS · AUTOMATIC TRANSMISSION [23] · страница 91 из 128 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
AUTOMATIC TRANSMISSION FLUID CHANGE
Caution
If ATF change is requireddue to damage to the trans-
mission, be sure to clean the cooler system:
(1) Raise the vehicle on hoist Place a drain container with large
opening under the drain plug (located in bottom of the oil
pan):
(2) Remove the drain plug to let ATF drain
(3) Install the drain plug and new gasket and tighten to 21Nm
(2.1 kgm; 15 ft lbs ) ]
(4) Refill ATF through the oil level gauge hole until its level
reached at COLD lower limit of the level gauge.
(5) Start the engine and allow to idle for at least two minutes_
Then,withthe parkingbrakeandservicebrake applied,
move the selector lever through all positions and finally
place in the "N" or "P" position.
(6) After the transmission is warmed up to the normal operating
temperature, recheck the fluid level, which must be between
the HOT upper limit and HOT lower limit marks.
(7) Insert the dipstickfullyto prevent dirtfromentering the
transmission:
TRANSFER OIL INSPECTION AND CHANGE
Refer to GROUP 22 _ Service Adjustment Procedures
Mitsubishi Motors CorporationDec , 1993
THROTTLE CABLE CHECK AND ADJUSTMENT
<3000, 3500>
(1) Check for defectiveor bent throttle lever or throttle cable
bracket:
(2) With the accelerator depressed, check to be sure that the
distancebetween the inner cable stopper anddust cover
surface is within the standard value.
Standard value: 0-1mm (0-0.0394 in.)
(3) If outside the standard value. adjust with adjusting nut
PWJE9086-E
Оригинальная страница руководства
