MANUALS · STEERING [37] · страница 9 из 52 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
CHECKING OF THE STEERING WHEEL RETURN To CENTRE (POWER STEERING)E37FGAA
To check for the returnof steeringwheel tocentre, carry
out drive test and check the following points:
Make gentle and sharp turns &nd check to geta feel for
that there is no appreciable difference in steering effort
and return to centre between right ad left turns_
Drive atspeed ofabout 35km/h (22mph),turn the
steeringwheel909 clockwiseor counterclockwise,and
release thewheelsecondOr twolaterIf the wheel
returnsmorethan709 ,thereturnmaybe considered
good:
NOTE
When the steering wheel is turned abruptly, momentary
hard steering might result, but this does not mean any
problem It is caused by low oil pump delivery during id-
ling:
DRIVE-BELT TENSION CHECK (POWER STEERING)
E37FHAI
Measure the flexion of the V belt when it is subjected to
a force of 10 kg in the place shown
Standard value:
mm (in:)
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| 2400 | 3000-12 VALVE | 3500 | |
|---|---|---|---|
| When checked | 6.0-10,.0 (0.236-0.394) | 9.0-14.5 (0.354-0.571) | 13.0-17.0 (0.511-0.669) |
| When a new belt is installed | 5.5 (0.217) | 8.0 (0.315) | 11.0-13.0 (0.433-0.511) |
| an old belt is When installed | 7.0 (0.2761 | 10.0 (0.394) | 14.0-16.0 (0.551-0.630) |
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| 3000 | 250 | 0D | |
|---|---|---|---|
| 24 VALVE | V type | V-ribbed type | |
| When checked | 10.5-14.5 (0.413-0.571) | 9.0-11.0 (0.354-0.433) | 8.0-12.0 (0.315-0.472) |
| When a new belt is installed | 9.5-11.5 (0.374-0.452) | 7.0 (0.2761 | 6.0-8.0 (0.236-0.315) |
| When an old belt is installed | 11.5-13.5 (0.452-0.531) | 9.5 (0.374) | 9.0-11.0 (0.354-0.433) |
2If the flexion value is outside the standard value, adjust
by the following procedure.
Оригинальная страница руководства
