MANUALS · STEERING [37] · страница 25 из 52 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

8.INSTALLATION OF ADJUSTING SPACER

(1) Install the adjusting spacer to the adjusting bolt and
measure the cross-shaft axial play:
Standard value:0.05 mm (0.0020 in.) or less

(2) Ifthemeasuredvalueisnotwithinthestandard
value ,makeadjustment bychangingtheadjusting
spacer:.

INSTALLATION OF TOP COVER AND CROSS-SHAFT ASSEMBLY

Lubricate the bearings and the gear teeth of each shaft.
(1)Movetheballnutofthe mainshafttothecentre
position (straight-ahead position)

Caution

Use care not to damage the cross-shaft oil seal:

(2)Turn the adjusting boltor3 timesuntil thetooth
surfaces are in contact.

(3) Measure the mainshaft total starting torque.
Secure the flange part of the gear box housing in
a vise.

Measurethemainshafttotal starting torqueby
usingthe special tools.

Standard value:0.65-0.85 Nm

(6.5-8.5 kgcm, 5.7-7.3 in.Ibs )

NOTE

The mainshaft should rotate smoothly across the
entire range

If themeasured value is not within the standard
or
value, adjust by turningthe adjusting bolt
out

If it can not be adjusted to the standard value by
turningthe adjustingbolt;checkthe following
points

ACross-shaft eccentricity due to improperlyin-
stalled top cover

BCross-shaft needle roller bearing damaged
CEnd cover improperly installed

2INSTALLATION OF PITMANARM

Feb: 1991

Install the pitman arm to the gear box with the mating
marks aligned:

Оригинальная страница руководства