1984-Montero · electrical a · страница 83 из 169 · Открыть оригинал PDF ↗
REASSEMBLY
Perform reassembly jn reverse procedure of disassembly, pay
attention to the following item:
1. Before rotor is attached to rear bracket, insert wire
through small hole made in rear bracket to lift brush.
After rotor has been installed, the wire can be removed.
5. Install drive belt and adjust the drive belt tension.
6. Tighten first the brace bolt and then tighten the support
bolt nut to the specified torque.
Tightening torque:
Alternator brace bolt . . . . . . 12-14 Nm (9-10 ft.lbs.)
Alternator support bolt nut . . . . . . . . . . . . . . . . . ,
20-24 Nm (15-l 8 ft.lbs.)
7. Connect wiring and connector to the alternator.
8. Connect the battery ground cable.
Оригинальная страница руководства
