1984-Montero · electrical a · страница 169 из 169 · Открыть оригинал PDF ↗
POWER WINDOW RELAY
Проверка
Check for continuity between the terminals with the power
ON and OFF.
While power is OFF
Between terminals 1 - 2 . . . . . . . no continuity
Between terminals 3 - 4 . . . , . . , . . . continuity
While power is ON
Between terminals 1 - 2 . . . . . . . . . . continuity
3-POINT ELR SEAT BELTS WITH TENSION RELIEFERS
SEAT BELT SWITCH
Inspection
1. Pull back the floor mat and disconnect the seat belt switch
connection from where it is at the attachment to the
buckle stalk assembly.
2. Use an ohmmeter to check the YB wire and the B wire
for breakage. (16W733)
3. If there is no continuity when the buckle is unlocked
and continuity when it is locked, the seat belt switch can
be assumed to be functioning properly.
4. If a microswitch is defective, the buckle stalk assembly
containing the microswitch should be replaced. For re-
placement. (Refer to GROUP 23.)
SOLENOID
Проверка
1. Lock the buckle and set the ignition key to “ON”.
2. Pull the seat belt out slightly from the retractor and allow
about 40 mm (1.5 in.) to be taken up.
3. Pull the seat belt out again and let go of it. If the retrac-
tor stops and there is slack in the seat belts, the solenoid
can be assumed to be funcitoning properly.
4. If the results of the above test are not satisfactory, in-
spect the seat belt switch. If no problem can be found,
replace the entire seat belt assembly in order to replace
the seat belt solenoid.
Оригинальная страница руководства
