1984 · Электрооборудование — страница 85

REMOVAL · 85

1984-Montero · electrical a · страница 85 из 169 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 85

cl -+

REMOVAL

1. Disconnect battery ground cable.

2. Disconnect starting motor harness from the starter
motor.

3. Remove the two starting motor mounting bolts and
remove starter motor.

Иллюстрация 2, страница 85
Иллюстрация 3, страница 85
Иллюстрация 4, страница 85

INSPECTION (after removal)

Pinion Gap Adjustment

1. Disconnect field coil wire from M-terminal of magnetic
switch.

2. Connect a 12 V battery between S-terminal and M-
terminal. (6EL050)

3. Set switch to “ON”, and pinion will move out.
Caution

This test must be performed quickly (in less than 10 seconds)
to prevent coil from bourning.

Иллюстрация 5, страница 85

4. Check pinion to stopper clearance (pinion gap) with a
feeler gauge. (6EL003)

If pinion gap is out of specification, adjust by adding or
removing washers between magnetic switch and front
bracket.

Pinion gap . . . . . . . . . . . 052.0 mm (.020-.079 in.)

Иллюстрация 6, страница 85
Иллюстрация 7, страница 85
Иллюстрация 8, страница 85

5. Lightly push back the pinion, and measure the amount
of travel, which represents the pinion gap. Adjust the
thickness (number) of washers at switch area so that the
gzip becomes 0.5 to 2.0 mm (-020 to .079 in.).

Иллюстрация 9, страница 85
Оригинальная страница руководства
COMPONENT SERVICE-STARTING SYSTEM cl-+
100%

Назад
Сверху