Pajero II Workshop Manual 1991 · Электрооборудование двигателя · страница 45 из 54 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
GLOw PLUG RELAYSAND2 INSPECTION
(1) Check that there is continuity (approxbetween the
glow plug relay (C) terminal and the bracket (earth):
(2) Use jumper leads to connect the glow plug relay terminal
(C) with the battery+) terminal and the bracket with the
battery (~) terminal.
Caution
(1) Beforeusingthe jumper leads, the harnesses con-
nectedto glowplugrelay(B) and (G)Terminals
must always be removed:
(2) Donotshortoutthedisconnected harness-side
terminals to the earth
(3) Be extremely careful when connecting the jumper
leads, as if the terminals are connected incorrectly,
itwill damage the relays
(3) Check the continuity between glow plug relay (B) ad (G)
terminals with the jumper lead connected from the battery
(-) terminal andwith the jumper lead disconnected_
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Jumper lead from battery (~) ter- minal | Continuity between (Bl and (G) terminals |
|---|---|
| Connected | Continuity (0.01 Or less) |
| Disconnected | No continuity 0)) |
GLOw PLUG INSPECTION
Remove the glow plug plate
(2) Measure the resistance between the glow plug terminals
and the body.
Standard value: 0.20-0.26 02 [at 5-35*C (41-959F)]
DROPPING RESISTOR INSPECTION
Disconnect the dropping resistor connector.
(2) Measure the resistance betweenthe droppingresistor
terminals
Standard value: 0.14-0.16 $
Оригинальная страница руководства
