Pajero II Workshop Manual 1991 · Электрооборудование двигателя · страница 50 из 54 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(2) Disconnect the glow control unit connector and check the
continuity between the harness-side connector terminals

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Inspection terminal	Inspection item	Continuity (resistance value)
5-7	Glow plug relay	Continuity 2092) (approx.

GLOW PLUGRELAY INSPECTION

(1)Check that there is continuity (20between glow plug
relay terminal (C) and terminal (El

(21Use jumper leads to connect the glow plug relay terminal
(C) with the battery ( + ) terminal and terminal (E) with the
battery (-) terminal

Caution

(1) Before using the jumper leads, the harnessescon-
nected to glow plug relay (B) and (G) terminals must
alwaysbe removed:

(2) Donotshortoutthedisconnectedharness-side
terminalsto the earth

(3) Be extremely careful when connecting the jumper
leads, as if the terminals are connected incorrectly
it will damage therelays:

(3) Check the continuity between glow plug relay (B) and (G)
terminals with the jumper lead connected from the battery
terminal andwith the jumper leaddisconnected:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Jumper lead from battery (~) ter- minal	Continuity between (B) and (G) terminals
Connected	Continuity (0.01 or less)
Disconnected	No continuity 02)

GLOw PLUG INSPECTION

Remove the glow plug plate_

(21Measure the resistance between the glow plug terminals
andthe body:

Standard value: 0.22-0.2802 [at 5-358C (41-959F)]

ENGINE COOLANT TEMPERATURE SENSOR INSPECTION
Refer to P.16-28,

PWJE9086

Оригинальная страница руководства