1987-Montero · Vol2 a · страница 190 из 284 · Открыть оригинал PDF ↗
SERVICE ADJUSTMENT PROCEDURES WIPE#l BLADE RUBBER REPLACEMENT NOBKIAA WINdSHIELD WIPER
1. Pull out the rubber and backing blade from the stopper
side.
2. Remove the backing blade from the rubber.
3. To attach a new rubber, assemble the rubber and backing
blade, insert from the direction opposite the stopper, and
secure by the stopper. Note that, because the backing
blade is curved, installation should be as shown in the
figure.
REAR WIPER
1. Pull out one side of the wiper blade rubber from the
stopper.
2. Pull out the wiper blade rubber, and then remove the blade
rubber.
3. Installation of the new blade rubber is the reverse
procedure of removal.
( ST6 Revision
Оригинальная страница руководства
