1989-Mitsu-Factory Manual · fuel system · страница 3 из 53 · Открыть оригинал PDF ↗
SERWCE SPECIFICATIONS
| Items | Specifications |
|---|---|
| Standard value | |
| Engine adjustments | |
| Basic ignition timing | 7”+ 2”BTDC at curb idle |
| Actual ignition timing at high altitude-Federal/California and high altitude vehicles for Federal | Approx. 12”BTDC |
| Curb idle speed wm | |
| For the first 500 km (300 miles) | 725:;;; |
| After 500 km (300 miles) | 800-c 100 |
| Throttle opener adjustment | |
| Rpm for air conditioner load rpm (when air conditioner ON) | 900-950 |
| Dash pot touch rpm wm | 2000 |
| Throttle-position sensor | |
| Adjustment voltage (throttle valve completely closed) V | 0.250 |
| Carburetor | |
| Main jet - primary | # 107.5 |
| secondary | #I90 |
| Pilot jet- primary | #55 |
| secondary | #70 |
| Enrichment jet | #65 |
| Automatic choke heater | Continuity-approx. 6 D [at 20°C (68”F)] |
| Choke breaker opening mm (in.) | |
| 1 st stage | 2.3-2.5 (.091-0.98) |
| 2nd stage | 3.0-3.2(.118-,126) |
| First idle rpm | Approx. 2,350 |
| Feedback solenoid valve coil resistance n | 54-66 [at 20°C (68”F)] |
| Slow cut-off solenoid valve coil resistance D | 48-60 [at 20°C (68”F)] |
| Throttle-position sensor resistance kn | 3.5-6.5 |
| Input sensor | |
| Engine coolant temperature sensor resistance kD | |
| 20°C (68°F) | 2.5 |
| 80°C ( 176°F) | 0.3 |
| Oxygen sensor output voltage V | Approx. 1 |
| Vacuum switch | ON more than 40 kPa (5.8 psi) OFF less than 26 kPa (3.9 psi) |
| Output actuator | |
| Secondary air solenoid valve resistance n | 36-44 [at 20°C (68”F)] |
| Throttle opener control solenoid valve resistance n | 40-48 [at 20°C (68’F)] |
Таблица в оригинале
Оригинальная страница руководства
