1989-Mitsu-Factory Manual · fuel system · страница 51 из 53 · Открыть оригинал PDF ↗
lNSPECTlON
l Check the hoses and the pipes for crack or damage.
l Check the fuel tank cap for malfunction.
l Check the fuel tank for deformation, corrosion or crack.
l Check the fuel tank for dust or foreign material.
NOTE
If the inside of the fuel tank is to be cleaned, use any one
of the following:
(I) Kerosene
(2) Trichloroethylene
(3) A neutral emulsion type detergent
e Check the in-tank fuel filter for damage or clogging.
l Check the check valve for malfunction.
CHECKING OVERFILL LIMITER (TWO-WAY VALVE)
A simple way of inspection, however, may be adopted in
which the overfill limiter is removed and then air is lightly
blown into either the inlet or outlet. If the air passes after a
slight resistance, overfill limiter is in good condition.
SERVICE POINTS OF INSTALLATION
NIGOAE
13. INSTALLATION OF RETURN HOSE/lZ. MAIN HOSE/4. VAPOR HOSE
When attaching the hoses to the pipes, be sure that the
hose is attached until its end comes in touch with the
bulge of the pipe as shown in the illustration.
9. INSTALLATION OF BREATHER HOSE/8. FUEL FILLER HOSE
Insert the hoses until their ends contact the fuel tank.
5. INSTALLATION OF CHECK VALVE
Install the check valve to the fuel filler hose protector so
that the check valve’s arrow faces as shown in the figure.
Оригинальная страница руководства
