Pajero II Workshop Manual 1991 · Автоматическая коробка передач · страница 62 из 128 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
DIAGNOSTIC FUNCTIONS
Меры предосторожности перед началом работ
(1)battery voltage is low, diagnostic trouble codes will not be
output Accordingly. check the battery before carrying out
inspection.
(2) If the battery is disconnected or if the engine control unit
connectorisdisconnected,the diagnostictroublecode
memory will be erased.
Accordingly.the battery shouldnot be disconnecteduntil
reading of the diagnostic trouble codeshasbeen completed.
READING THE DIAGNOSTIC TROUBLE CODES
<Whenusingthe MUT-ID
Caution
Connection and disconnection of the MUT-II should always
be carried out with the ignition switch in the OFF position.
(1) Connect the MUT-II t0 the diagnosis connector.
(2) Turn the ignition switch to ON.
(3) Take & reading of the diagnostic code output
(4) Repair the malfunction location while referring to the In-
spection Procedures For Each Diagnostic Trouble Code.
5) Turn the ignition switch to OFF and then back to ON again:
6) Erase the diagnostic trouble codes
Check that the diagnostic code output iS normal.
<When using the oil temperature warning lamp>
(1) Use the special tool (diagnostic trouble code check harness)
to earth terminal 0 of the self-diagnosis connector
(2) Takereading of the diagnostic trouble codes from the
flashing of the oil temperature warning lamp
(3) Repair the malfunction location while referring to the Chart
Classified by Diagnostic Trouble Codes
(4) Erase the diagnostic trouble codes by the following pro-
cedure:
Turn the ignition switch to OFF.
After disconnecting the battery cable from the negative
battery terminal for 10 seconds or more, re-connect the
cable
Turn the ignition switch to ON,takereading of the
diagnostic code output and check that a normal code is
output
After the engine has warmed up, run it at idle for about
10 minutes
ADDED
Оригинальная страница руководства
