Pajero II Workshop Manual 1991 · Автоматическая коробка передач · страница 111 из 128 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF REMOVALE23IBAE

11, REMOVAL OF TRANSFER CONTROL LEVER ASSEMBLY
Whenremovingthetransfercontrolleverassembly,
move the transfer control lever to the 2H (2 wheel drive-
high range) position:

Проверка

EZJICAJ

Check the transmission control cable assembly for func
tion and for damage_

SERVICE POINTS OF INSTALLATIONEZ3IDAK 11. INSTALLATIONOF TRANSFERCONTROL LEVER AS- SEMBLY

(1)Remove the adhesive sticking to the transfer control
lever assembly mounting bolts_

(21 Usea tap (M8 x1.25) to remove the adhesive stick-
ingto the transfer control lever assembly installation
holes.

(3) Checktobe sure thatthe return spring is set to the spring
stopper of the 2-4WD shift lug, and then install the con-
trol lever in the position shown by the arrow

(4} Apply specified adhesive to the threads of the lever as-
sembly mounting bolts, and then tighten the transfer
control lever

Specified adhesive: 3M Stud Locking No. 4710Or equivalent

INSTALLATION OF TRANSMISSION CONTROL CABLE ASSEMBLY (SELECTOR LEVER ASSEMBLY SIDE)

After installing the transmission control cable, adjust it by
the following procedure.

Move the selector lever to the"Nposition.

(1)

(2)Loosen the adjusting nut, gently pull the end of the
transmissioncontrolcableinthedirectionofthe
arrow and then tighten the adjusting nut_

REVISED

PWJE9086-A

Оригинальная страница руководства