Pajero II Workshop Manual 1991 · Автоматическая коробка передач · страница 106 из 128 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
CONTROL CABLE
Whether control cable is properly adjusted can be confirmed
by checking whether inhibitor switch is performing well.
Apply parking brakes and service brakes securely:
2Place selector lever to "R
range
3Set ignition key toST"position
Slowly move the selector lever upward until it clicks as it
fitsinnotchofP"range.startermotoroperates
when lever makesa click,position is correct:
5.Then slowlymoveselectorleverto'N" range bythe
sameprocedureasin foregoingparagraph:Ifstarter
motor operateswhenselectorleverfitsin"N"NS
position is correct:
Also check to be sure the vehicle doesn't begin t0 move
and the lever doesn't stop between P-R-N-D
Thecontrolcable isproperly adjustedas described
above,thestartermotorstartsatboththePrange
and theN"range
AWD INDICATOR CONTROL UNIT CHECK
Refer to GROUP 22-Service Adjustment Procedures.
SPEEDOMETER CABLE REPLACEMENT
E23FKAA
E23FPAD
Refer to GROUP 22-Service Adjustment Procedures.
TRANSFER OIL SEALS REPLACEMENT
EZZFAAF
Disconnect the propeller shaft from the transfer. (Refer
to GROUP 25-Propeller Shaft )
2Usingflat-tip (~) screwdriver,remove the oil seal.
3Using the special tool,tap the transfer oil seal into the
transfer.Note in illustration the direction of installation of
transfer oil seal.
Applycoatingof the transmission oil to the lip of the
oill seal;
Transmission oil:
Hypoid gear oil API GL-4, SAE 75W-90 or 75W-85W
PWJE9086-€
Оригинальная страница руководства
