Pajero II Workshop Manual 1991 · Автоматическая коробка передач · страница 90 из 128 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE ADJUSTMENT PROCEDURES AUTOMATIC TRANSMISSION FLUID INSPECTION

Place the vehicle on a level surface.

(2)Before removing the dipstick, wipe all dirt form area around
the dipstick

(3) With the selector lever in the "P" position ad the parking
brake applied, start the engine

(4) The engine should be running at idleandthe transmission
should be warmed up sufficiently. [fluid temperature70-
80PC158 -1769F)]

(5)Move the selector lever through all positions to fill the torque
converter and hydraulic circuit with fluid.Then place the
lever in the'N" position.

(6) Check that fluid level iS at oil level gauge "HOT"If fluid level
is low. add fluid to'HOT" level.
Transmission fluid:DIA QUEEN ATF-SP or equivalent

NOTE

Low fluid level can allow the oil pump to take in air together
with fluid, leading to various troubles Air trapped in hydraulic
circuit forms bubbles whichmake thefluidThis
spongy:
lowers pressureand shows down pressure buildup. If the
transmission has tOo much fluid,gearschurn up foam and
causesameconditionsaswhenthe fluid levellow,
resulting in premature deterioration of ATF In either case, air
bubblescancause overheatingandfluidoxidationand
varnishing, which can interfere with normal valve, clutch and
servo operation. Foaming can also result in fluid escaping
from the transmission vent where it may be mistaken for
fluid leak

(7) Check fluid condition;

NOTE

When fluid smellsburned,itis contaminatedwithmetal
bushing or friction material particles and hence a complete
overhaul of the transmission is needed. Be sure t0 examine
fluid on the dipstick closely.

(8) After fluid has been checked, insert the dipstick until it is
seated fully t0 seal out water and dirt

Оригинальная страница руководства