1998 · FUEL [13] · страница 16 из 104 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

READ OUT OF MALFUNCTION CODE

Precautions for Operation

(1)When battery voltage is low,no detection of failure is
possible. Be sure to check the battery for voltage and
other conditions before starting the test

(2) Diagnosis item is erased if the battery or the engine
control unit connector is disconnected. Do not disconnect
thebattery before the diagnosis result is completely read.
Be sure to connect or disconnect the MUT-II with the
ignition switch turned off.

WHEN USING THE MUT-II

Caution

Turn oft the ignition switch before disconnecting or
connecting the MUT-II

Connect the MUT-II to the diagnosis connector:
Turn the ignition switch to ON

Take a reading of the diagnosis output

Repair the problem location, referring to the diagnosis
chart:

(5)After turning the ignition switch once to OFF; turnit back
to ON:

Erase the diagnosis code

Recheck to be sure that the condition is normal.

WHEN USING THE ENGINE WARNING LAMP (CHECK ENGINE LAMP)

(1) Use the special tool (diagnosis code check harness) to
earth the diagnosis test mode control terminal (terminal
0) ofthediagnosis control terminal (16 pin):

Turn the ignition switch to ON:

3)Takereading ofdiagnosis output according to how
often the engine warning lamp flashes_

(4)Repair the problem location, referring to the diagnostic
chart:

(5)Erase the diagnostic code by the following procedure.
Turn the ignition switch to OFF

After removing the battery cable from the battery
terminals for 10 seconds or more, reconnect the
cable

Warm up the engine and let it idle for approx:15
minutes:

Turn the ignition switch to ON and takereading of
the diagnostic output to check if a normal code is
output.

Оригинальная страница руководства