1998 · FUEL [13] · страница 77 из 104 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Check for continuity of the earth circuit:
SENSOR INSPECTION <OXYGEN SENSOR (FRONT)>
Disconnect the oxygen sensor connector:
Check that there is continuity [4.58.02 at 20*C]
between oxygen sensor connector terminaland
terminal
(3) If there is no continuity, replace the oxygen sensor:
(4)Warm the engine until the engine coolant temperature
reaches 80PC or more.
(5)Use the jumper Ieads to connect the oxygen sensor
terminal 0 (connect (+) terminal) and terminal
(connectterminal) to the battery (+) and (~) terminals
respectively:
Caution
Be careful when connecting the jumper leads, as
connecting the terminals incorrectly will damage the
oxygen sensor:
(6) Connectdigital-type voltmeter to terminaland
terminal
While repeatedly racing the engine, measure the oxygen
sensor output voltage_
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Engine | Oxygen sensor output voltage | Notes |
|---|---|---|
| When racing the engine | 0.6_ 1.0 V | When the airlfuel mix- ture ratio is enriched by racing the engine repeatedly, a normal oxygen sensor will output a voltage of 0.6-1.v |
NOTE
For removal and installation of the oxygen sensor; refer to
GROUP 15Exhaust Pipe,Main Muffler and Catalytic
Converter
Оригинальная страница руководства
