1998 · FUEL [13] · страница 21 из 104 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

IDLE POSITION SWITCH AND THROTTLE
POSITION SENSOR ADJUSTMENT

Connect the MUT-II to the diagnosis connector:
When not using the MUT-II, proceed as follows;
(1) Disconnect the connector of the throttle position
sensor:

(2) Connect an ohmmeter between terminal 2 (idle
position switch) and terminal(sensor earth) by using
jumper wires_

2Insert a thickness gauge as follows:
Inserta thickness gauge witha thickness of 0.65 mm
between the fixed SAS and the throttle lever:

3Turn the ignition switch to ON (but do not start the engine)

Loosen the throttle position sensor mounting bolt; and then
turn the throttle position sensor clockwise as far as it will
go

5,Check that the idle position switch is ON at this position.
6_Slowly turn the throttle position sensor counterclockwise
and find the point where the idle position switch turns off_
Securely tighten the throttle position sensor mounting bolt
at this point:

When not using the MUT-II, proceed as follows;

(1) Disconnect the throttle position sensor connector; and
connect the special tool (test harness: MB991348) in
between_

(2) Connect digital voltmeter between terminal 3 (sensor
output) and terminal 1 (sensor earth)

(3) Turn the ignition switch to ON (but do not start the
engine)

Оригинальная страница руководства