MANUALS · REAR AXLE [27] · страница 11 из 50 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Limited slip differential
HypoidgearoilMITSUBISHIGenuineGearOil
Part No. 8149630 EX
CASTROL HYPOY LS (GL-5, SAE 90),
SHELL-LSD (GL-5, SAE 80W-90) or equivalent
<Vehicles built up to October, 1993>
Standard wheelbase
2400 , 250OD1.8 (1.90, 1.58)
30002.6 (2.75, 2.29)
Long wheelbase
2500D*'1.8 (1.90, 1.58)
2400 , 3000, 250OD*22.6 (2.75, 2.291)
<Vehicles builtfrom November , 1993>
2400 , 250OD1.8 (1.90,1.58}
30002.6 (2.75, 2.29)
3500 , 28OOD3.2 (3.38, 2.82)
Rear differential lock
HypoidgearoilAPI classificationGL-5or higher
SAE viscosity No. 90, 80W
<Vehicles built up to October, 1993>
2400 , 3000, 250OD2.6 (2.75, 2.29)
<Vehicles built from November, 19937
2400 , 3000, 2500D2.6 (2.75, 2.29)
3500 , 2800D3.2 (3.38, 2.82)

NOTE

*1Vehicles without wide fender-AT.

*2: Vehicles with wide fender and vehicles without wide
fender-MT.

Without special tool

LIMITEDSLIPDIFFERENTIALPRELOADMEA- SUREMENTE27FIAA

E27FIAA

Tomeasurethe preload of the limited slip differential,set
theshift leverof the transmissionto theneutral position,
lockthe front wheels, and fullyrelease the parkingbrake
One of the rear wheels should be maintained in contact with
the ground surface, and the other should be.raised up.
Measure the starting torque at the side on which the wheel
is in the raised position by using the following procedures_

(1)Remove the wheel

(2)Mount the special tool to the hub bolts by using the hub
nuts

(3) Find the limited slip differential preload by measuringthe
axle shaft starting torque in the forward direction with
torque wrench

Standard value:Using the special tool
12.5Nm(1.25 kgm, 9 ft lbs) or
more
Without using the special tool
25Nm (2.5 kgm,18 ftIbs )Or
more

(4) If the torque is less than the standard value, remove the
limited slip differential from the vehicle ad disassemble
it.

Оригинальная страница руководства