MANUALS · REAR AXLE [27] · страница 12 из 50 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
AXLE HOUSING OIL SEAL REPLACEMENTEZ7FKAD
Release coupling between parking brake cable and back-
ing plate_
2Before disconnecting the brake pipe, drain the brake fluid
from the bleeder screw.
Remove the nutssecuring the backing plate to the axle
housing:
Pull the rear axle shaft from axle housing: If the rear axle
shaft is hard to remove, use the special tools.
5Use special tools withhook attached to remove the oil
seal.
6Apply multipurpose grease to the oil seal fitting area of
the rear axle housing:
Drive the new oil seal into therear axle housing end by
using the special tool.
Applymutipurpose grease to the oil seal lip.
9Install the rear axle shaft:
10.Installthebraketubeand perform air bleeding of the
brake system from the air bleeder.(Refer to GROUP 35
Service Adjustment Procedures:)
11 .Installtheparkingbrakecableandadjusttheparking
brake lever stroke_(Refer to GROUP36ServiceAd-
justment Procedures )
Оригинальная страница руководства
