MANUALS · REAR AXLE [27] · страница 48 из 50 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF DISASSEMBLYEZ6WLAB REMOVAL OF SCREW

(1) Evenly loosen4 screws on case A and B to remove_
Set caseB downward and remove case A,side gear
spacer (RH) and side gear (RH)

NOTE

Check differential gear backlash to determine neces-
sity of disassembling side gear (RH) and onward.

DIFFERENTIAL GEAR BACKLASH CHECK

Check differential gear backlash as follows

(1) Insertclothwrappedscrewdriverthroughsideof
caseB and lock side gear (LH) and pinion gear(one
piece)

(2) Contact dial gaugeon pinion gear facing the locked
pinion gear and measure backlash within the standard
value

NOTE
Measure2 pinion gears_

Standard value:

Conventional differential

0.10-0.25 mm (0.004-0.01 in)

Vehicles with rear differential lock
0.15-0.20 mm (0.005-0.008 in.)

(3)Whenbacklashexceedsthe standard value,adjust
side gear spacer (LH).

NOTE

If backlash iswithinthestandard value, assureap-
propriategearspacer(RH)thicknessand assemble
differential case assembly.

Проверка

MZZIHAC

Wash the disassembled parts in cleaning solvent,drythem
using compressed air,and then check the following areas:
Check the side gears, pinion gears and pinion shaft for
wear or damage_

Check the side gear spline for wear or damage.

Оригинальная страница руководства