MANUALS · REAR AXLE [27] · страница 29 из 50 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

DRIVE GEAR RUNOUT

Measurethedrivegearrunoutattheshoulderonthe
reverse side of the drive gear:

Limit:0.05 mm (0.0019 in.)

DIFFERENTIAL GEAR BACKLASH (No. 6 conventionaldif-
ferential and No.7 conventional differential)
While lockingtheside gearwiththewedge ,measure the
differential gear backlash withindicator on the pinion gear
Standard value:<No.6 differentialz
0.010-0.076mm (0.0004-0.0030 in:}

<No.differentialz

0-0.076 mm (0-0.0030 in.)
Limit:0.2 mm (0.0079 in )

FINAL DRIVE GEAR TOOTH CONTACT

Refer to GROUP 26Differential Carrier.

Блокировка заднего дифференциала

Connect anair hose, pressure gauge &ndair regulator,
foradjustingtheoutsideairpressure,totheactuator
pipe

2Adjust the outside air pressure with the air regulator until
the pressure gauge showspressure of approx25 kPa
(0.25 kglcm' ,4 psi:).

3_Use the special tool to gently turn only the side gear of
one side of the axle 1/4-1/2 turns.
NOTE

The lockwillnot operate straight away, evenwhen
air pressure is supplied, so the side gear on one side
of theaxle isturnedSOthattheclutchwillmesh
(lock)

2To unlock,; stop the supply of air pressure, and gently
turnthe sideonone side of theaxle1/4-1/2
gear
turns

Measuretherotation torque of the companion flange,
and check the lock condition andfreeconditionof the
rear differential.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Rear differential operation	Companion flange Nm (kgm, ft.Ibs ) [N (kg, Ibs)]
Locked	Doesn't turn at 50 (5, 36) [1,111 (111, 248)]
Free	Turns at less than 50 (5, 36) [1,111 (111, 248)}

Оригинальная страница руководства