MANUALS · REAR AXLE [27] · страница 44 из 50 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

ADJUSTMENT OF CLUTCH PLATE FRICTION FORCE

Before assembly, use the following method to adjust the
clearancebetweenthespringplatesanddifferential
cases (for adjustment of theclutch plate friction force)
and to adjust the end play of the side gear when install-
ing the internal components into the differential case

(1) Arrangethetwo(each)frictiondiscsandfriction
platesforeachside,oneontopofanother ,as
shown in the figure, combining them so that the dif-
ference in thickness between the left ad the right is
the standard value.

Standard value:0-0.05mm (0-0.0020 in )

NOTE

For new onesthere is one type of friction plate: 1.75
mm (0.0689 in:); there are two types of friction disc:
1.75 mm (0.0689 in ) and 1.85 mm (0.0728 in:).
(2) Arrange the two spring plates for eachside one on
top of the otheras shown in the illustration, so that
the differencebetweenthe left andthe right thick-
ness is minimized

NOTE

For new ones, there.is one type of spring disc and
spring plate: 1.75 mm (0.0689 in:).

1Po085

(3) Assemblethepressurering's internal components
(differential pinionshaftandpressure ring)andthe
friction discs and friction plates, ad thenas shown
in the figure, measure the overall width.

(4) Calculate the total value (C) of the thickness of the 2
sets of spring plate plus the value measured in (3)
above_

Оригинальная страница руководства