MANUALS · REAR AXLE [27] · страница 40 из 50 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(2) Measure the final drive gear backlash_

Standard value:<No6 differential>
0.11-0.16 mm (0.0043-0.0063 in.)
<No.differential andNo:7.5
differential (except rear differen-
tial lockl>

0.13-0.18 mm (0.0051-0.0071 in.)
<No.7.5differential(reardif-
ferential lockh>
0.12-0.18 mm (0.0047-0.0071 in.)

NOTE

Measureatleastpointsonthedrivegear
periphery.

(3) Using the special tool (MB990201) ,adjust the back-
lash to standard value by moving the side bearing nut
as shown

NOTE

First turn the side bearing nut for loosening, and then
turn (by the same amount)the side bearing nut for
tightening

(4) Usingthe specialtool,toapplythe preload,turn
down both right and left side bearing nuts on half the
distance between centres of two neighbouring holes

(5) Choose and install the lock plate (two kinds}

con-
(6) Check the final drive gear tooth contact:If poor
tact is evident,make adjustment(Refer to GROUP
26-Differential Carrier )

Measure thedrive gear runout
Limit:0.05 mm (0.0020 in,)

(8)Whendrive gearrunout exceedsthe limit,remove
the differential case and then the drive gears, moving
them to different positions and reinstall them.

Mitsubishi Motors CorporationDec_1993

Оригинальная страница руководства