1987-Montero · Rear Axle a · страница 18 из 56 · Открыть оригинал PDF ↗
REAR AXLE - Service Adjustment Procedures LIMITED SLIP DIFFERENTIAL PRELOAD MEA- SUREMENT NOJFDAD
1. To rneasure the preload of the limited slip differential, set
the shift lever of the transmission to the neutral position,
lock the front wheels, and fully release the parking brake.
One of the rear wheels should be maintained in contact
with the ground surface, and the other should be raised
up.
2. Measure the axle shaft turning torque at the side on which
the wheel is raised position by using the following
procedure:
(1) Remove the wheel.
(2) Mount the special tool to the hub bolts with the hub
nuts,
(3) Find the limited slip differential preload by measuring
the axle shaft turning torque in the forward direction
with a torque wrench.
NOTE
Esefore measuring the turning torque, turn the axle
shaft to remove any initial resistance.
Standard value : 35 Nm (25 ftlbs.) or more
(4) If the turning torque is less than the standard value,
remove the limited slip differential from the vehicle and
repair it. (Refer to P.3-45.)
:
‘..
:.
REPLACEMENT OF AXLE HOUSING OIL S$All~
1. Disconnect the parking brake cables from the equalizer
and then remove the clamps from the parking brake
cables. (Refer to GROUP 5 BRAKES - Parking Brake Cable.)
1. Disconnect
NOTE
Do not disconnect the parking brake cable and rear brake
connection.
2. Before
disconnecting the brake tube, drain the brake fluid
from the bleeder screw at the left side of the rear brake.
3. Pull the rear axle shaft with rear brake assembly attached.
If the rear axle shaft is hard to remove, use the special
tools.
/B Revision
Оригинальная страница руководства
