1987-Montero · Rear Axle a · страница 44 из 56 · Открыть оригинал PDF ↗
12. REMOVAL OF DRIVE PINION ASSEMBLY
(1) Make the mating marks to the drive pinion and
companion flange.
Caution
The mating mark made on the companion flange
must not be on the coupling surface of the flange
yoke and the rear propeller shaft.
(2) Drive out the drive pinion together with the drive pinion
spacer and drive pinion front shims.
13. REMOVAL OF DRIVE PINION REAR BEARING INNER RACIE
Pull out the drive pinion rear bearing inner’race by using
the special tools.
21. REMOVAL OF DRIVE PINION FRONT BEARING OUTER FUKIE
Drive out the drive pinion front bearing outer race from the
gear carrier.
22. REMOVAL OF DRIVE PINION REAR BEARING OUTER RACIE
Drive out the drive pinion rear bearing outer race from the
gear carrier.
INSPECJTON
NOBIMAA
Wash the disassembled parts in cleaning solvent, dry them
using compressed air, and then check the following areas:
l Check the companion flange for wear or damage.
l Check the oil seal for wear or deterioration.
l Check the bearings for wear or discoloration
l Check the gear carrier for cracks.
l Check the drive pinion and ring gear for wear or cracks.
Оригинальная страница руководства
