1987-Montero · Rear Axle a · страница 39 из 56 · Открыть оригинал PDF ↗
(3) Insert a wedge between the side gear and the pinion
shaft to lock the side gear.
(4) While locking the side gear with the wedge, measure
the differential gear backlash with a dial indicator on
the pinion gear.
Standard value : 0.01-0.076 mm (.0004-.0030 in.)
Limit : 0.2 mm (.008 in.)
(5) If the differential gear backlash exceeds the limit,
adjust the backlash by installing thicker side gear thrust
spacers.
(6) Measure the differential gear backlash once again, and
confirm that it is within the limit.
If adjustment is not possible, replace the side gears
and pinion gears as a set.
*<
22. INSTALLATION OF LOCK PIN
(1) Align the pinion shaft lock pin hole with the differential
case lock pin hole, and drive in the lock pin.
(2) Stake the lock pin with a punch at two points.
23. INSTALLATION OF DRIVE GEAR
(1) Clean the drive gear attaching bolts.
(2) Remove the adhesive adhered to the threaded holes of
the drive gear by turning the tap tool (Ml0 x 1.25),eand
then clean the threaded holes by applying compressed
air.
‘:’
‘,
(3) Apply the specified adhesive to the threaded holes of
the drive gear.
Specified adhesive : 3M adhesive stud locking 4170
or equivalent
(4) Install the drive gear onto the differential case with the
mating marks properly aligned. Be sure to tighten the
bolts to the specified torque in a diagonal sequence.
Оригинальная страница руководства
