1987-Montero · Rear Axle a · страница 55 из 56 · Открыть оригинал PDF ↗
(7)Remove the spring plates, spring discs, friction plates
and friction disc.
(8)lnstalI the thrust washer as shown in the figure, and
then select a thrust washer so that the difference
between the left and right dimensions from the
pressure ring rear face to the thrust washer end face is
the standard value.
Standard value : 0.05 mm (.0020 in.) or less
NOTE
Measure the distance while squeezing the V-shaped
groove manually.
(9)Measure the dimension (H) from the thrust washer end :,. ’
surafce to end surafce. l.&
.’
(10)Obtain the dimension (I) between the thrust washer
contact surfaces when differential cases (A) and (B) are
combined.
(I=J+K+L)
NOTE
Dimension J is the distance between the spring plate
contact surfaces when differential cases (A) and (B) are
combined. (Refer to P.3-54.)
(1 l)Change the thickness of the thrust washer so that the
clearance ( I - H ) between the thrust washer and the
differential case is the standard value.
Standard value : 0.05-0.20 mm (.0020-.0079 in.)
NOTE
I. Select the thrust washer so that the difference
between the left and right dimensions from the
pressure ring rear face and the thrust washer end
surface are the standard value even when the
thrust washer is changed.
2. There are three sizes of new thrust washers: 1.50
mm (.0591 in.), 1.60 mm (.0630 in.), and 1.70 mm
(.0670 in.)
(12)Place the each part in the differential case (B) as
directions shown in the figure.
Оригинальная страница руководства
