1987-Montero · Rear Axle a · страница 37 из 56 · Открыть оригинал PDF ↗
Carrier (Conventional Type)
(4) Position the special tool in the side bearing seat of the
gear carrier, and then select a drive pinion rear shim of
a thickness which corresponds to the gap between the
special tools.
NOTE
Be sure to clean the side bearing seat thoroughly.
When positioning the special tool, be sure that the cut-
out sections of the special tool are in the position
shown in the illustration, and also confirm that the
special tool is in close contact with the side bearing
seat.
When selecting the drive pinion rear shims, keep the
number of shims to a minimum.
,P
(5) Fit the selected drive pinion rear shim(s) to the drive !”
pinion, and press-fit the drive pinion rear bearing inner J‘
4
race by using the special tool.
i
‘!.a..
. ADJUSTMENT OF DRIVE PINION PRELOAD
Adjust the drive pinion turning torque by using the
following procedure:
Without Oil Seal
(1) Fit the drive pinion front shim(s) between the drive
pinion spacer and the drive pinion front bearing inner
race.
(2) Tighten the companion flange to the specified torque
by using the special tools.
NOTE
Do not install the oil seal.
(3) Measure the drive pinion turning torque (without the oil
seal)
Standard value : 0.4-0.5 Nm (3.5-4.3 in.lbs.)
,:/’
/.
i
‘i i. ;i
(4) If the drive pinion turning torque is not within the range
of the standard value, adjust the turning torque by
replacing the drive pinion front shim(s) or the drive
pinion spacer.
NOTE
When selecting the drive pinion front shims, if the
number of shims is large, reduce the number of shims
to a minimum by selecting the drive pinion spacers.
(5) Remove the companion flange and drive pinion once
again.
Оригинальная страница руководства
