1987-Montero · Rear Axle a · страница 53 из 56 · Открыть оригинал PDF ↗
(2) Inspect the contact and sliding surfaces listed below, and
repair any nicks and burrs by using an oil stone.
E The sliding surfaces of the thrust washer and the case.
F The spring contacting surface of the differential case.
G The contact surfaces of the outer circumference of the
pressure ring and the inner circumference of the
differential case.
H The sliding surface of the thrust washer.
I The sliding surfaces of the hole in the pressure ring
and the outer circumference of the side gear.
J The projection on the outer circumference of the
pressure ring.
K The spherical surface of the differential pinion. gear
and the inner diameter of the pressure ring. )
L The V-shaped groove in the pressure ring, and the V- ,,.,,“:”
ir’
shaped part in the pinion shaft.
M The outer diameter of the pinion shaft and the hole of ii
!
the differential pinion gear.
N The outer circumference groove of the side gear. ;,
0 The inner circumference groove of the differential !,- ,
case.
P The sliding surface of the thrust block.
Оригинальная страница руководства
