15. INSTALLATION OF BEARING INNER RAGE/14. REAR AXLE SHAFT

1987-Montero · Rear Axle a · страница 25 из 56 · Открыть оригинал PDF ↗

(1) Apply the specified grease to the roller surfaces of the
bearing inner race.

Specified grease : Multipurpose grease SAE 5310,
NLGI No. 2

(2) Install the rear brake assembly attached with bearing
case and the bearing inner race in that order to the axle
shaft.

(3) Press-fit the bearing inner race into the axle shaft using
the special tool.

(4) Pack the bearing case with the specified grease.

Specified grease : Multipurpose grease SAE J310,
NLGI No. 2

,ii’
‘t

13. INSTALLATION OF WASHER/12. LOCK WASHER/ll. LOCK NUT

Install these parts with cares described below.

(1) Apply the specified grease to the thread portion of the
axle shaft, to which the locking nut is installed.

(2) Align the washer tab with the slot of the axle.shaft to
install the washer.

(3) Align the lock washer tab with the slot of the axle shaft
to install the lock washer as figure.

(4) Install the lock nut with its chamfering in the directions
shown in the illustration.

(5) Tighten the lock nut to the specified torque by using
the special tool.

!I’

‘:

‘: :

(6) Bend the tab of the lock washer into the slot of the lock
nut.

NOTE

If the slot in the lock nut and the ta’b of the lock washer
are out of alignment, turn the lock nut in until they are
in alignment.

Оригинальная страница руководства