1987-Montero · Rear Axle a · страница 23 из 56 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL 6. DISCONNECTION OF BRAKE TUBES
Before disconnecting the brake tube, drain the brake fluid
from the bleeder screw at the right side of the rear brake.
8. REMOVAL OF REAR AXLE SHAFT ASSEMBLY
Pull the rear axle shaft with rear brake assembly attached.
If the rear axle shaft is hard to remove, use the special
tools.
NOTE
Do not damage the oil seal during its removal.
11. REMOVAL OF LOCK NUT
OF LOCK NUT j-
Remove the lock nut by following the steps below. r.:
(1) Straighten the bent tab of the lock washer with the ,”
screwdriver. ‘,
Il.
1
i
;*&, ,
yy+ +,
(2) Remove the lock nut by using the special tool.
(3) Remove the lock washer and the washer.
14. REMOVAL OF REAR AXLE SHAFT
(1) Reinsert the lock nut on the axle shaft approximately 1(”
three turns.
(2) Install the special tool as figure to remove the rear axle “f
shaft from the bearing case. i’
Be sure to install nuts and washers diagonally.
(3) Turn nuts with equal pressure to ensure smooth
removal of the wheel bearing.
18. REMOVAL OF BEARING OUTER RACE
Using a hammer and drift, remove bearing outer race from
bearing case.
19. REMOVAL OF OIL SEAL
Remove the oil seal from the end of rear axle housing with
the special tool, if necessary.
Оригинальная страница руководства
