1987-Montero · Rear Axle a · страница 19 из 56 · Открыть оригинал PDF ↗
4. Use special tool with hook attached to remove the oil seal.
5. Apply the specified grease to the oil seal fitting area of the
rear axle housing.
.t‘.*
.’
Specified grease : Multipurpose grease SAE J310, NLGl
No. 2
6. Drive the new oil seal into the rear axle housing end by;,,,.‘,
using the special tools. :r ,.’
. ‘.
7. Apply the specified grease to the oil seal lip.
Specified grease : Multipurpose grease SAE J310, NLGl
No. 2
8. Adjust the clearance between the bearing case and rear
axle housing end. (Refer to P.3-26.)
9. Install the rear axle shaft assembly to the rear axle housing.
10. Connect the brake tube and bleed out the air. (Refer to
GROUP 5 BRAKES-Service Adjustment Procedures.)
11. Connect the parking brake cable, and adjust the stroke of
the parking brake lever.
,.
-’
Standard value : 4-6 clicks
(Refer to GROUP 5 BRAKES-Service Adjustment Proce-
dures.) *
1
Оригинальная страница руководства
