1987-Montero · Rear Axle a · страница 28 из 56 · Открыть оригинал PDF ↗
9. REMOVAL OF REAR PROPELLER SHAFT
Make the mating marks on the flange yoke of the rear
propeller shaft and the companion flange of the differential
case.
10. REMOVAL OF DIFFERENTIAL CARRIER
Remlove the attaching nuts and strike the lower part of
differential carrier assembly with a square lumber several
times, to remove the assembly.
NOTE
Do not remove the uppermost nut but keep it loosened all
the way to the stud bolt end.
Caution
Use care not to strike the companion flange.
SERVICE POINTS OF INSTALLATION NOBIDAB 10. APPILICATION OF SEALANT TO DIFFERENTIAL CARRIER
NOBIDAB
When the differential carrier is installed, apply specified
sealant to the differential carrier mounting surface of the
axle housing as illustrated in either of the illustrations.
Specified sealant : 3M ART Part No. 8663, 8661 or
equivalent
9. INSTALLATION OF REAR PROPELLER SHAFT
Align the mating marks on the flange yoke and the
companion flange to install the rear propeller shaft.
Оригинальная страница руководства
