1987-Montero · Rear Axle a · страница 41 из 56 · Открыть оригинал PDF ↗
(4) Using the special tool, to apply the preload, turnn down
both right and left side bearing nuts on half the
distance between centres of two neighbouring holes.
(5) Choose and install the lock plates (two kinds).
(6) Check the final tooth contact. If poor contact is evident,
make adjustment. (Refer to P.3-29.)
(7) Measure the drive gear runout.
Limit : 0.05 mm (.OOZO in.)
If the drive gear runout exceeds the limit, reinstall by
changing the phase of the drive gear and differential
case, and remeasure
Оригинальная страница руководства
