1984-Montero · rear axle a · страница 8 из 43 · Открыть оригинал PDF ↗
| Symptom | Probable cause | Remedy |
|---|---|---|
| Heat | Insufficient gear backlash Excessive preload | Adjust |
| Insufficient oil | Replenish | |
| Oil leakage | Clogged breatherhose | Clean or replace |
| Cover insufficiently tightened Seal malfunction | Retighten, apply sealant, or replace the gasket | |
| Worn or damaged oil seal | Replace | |
| Excessive oil | Adjust the oil level | |
| LIMITED SLIP DIFFERENTIAL Abnormal noise during driving or gear changing | Excessive final ring gear backlash Insufficient drive pinion preload | Adjust |
| Adjust or replace | ||
| Replace | ||
| Retighten or replace |
Таблица в оригинале
NOTE
In addition to a malfunction of the differential carrier components, abnormal noise can also be caused by the propeller shaft
universal joint, the axle shafts, the wheel bearings, etc. Before disassembling any parts, take all possibilities into consideration
and confirm the source of the noise.
| Abnormal noise when cornering | Damaged differential gears Damaged pinion pft Nicked and/or abnormally worn inner or outer clutch plates Inferior gear oil Abnormally worn or damaged thrust washer | Replace |
|---|---|---|
| Insufficient gear oil quantity | Replenish | |
| Gear noise | Improper final ring gear tooth contact adjustment / | Adjust or replace |
| Incorrect final ring gear backlash Improper drive pinion preload adjustment | Adjust | |
| Damaged, broken, or seized tooth surfaces of the ring gear and drive pinion Damaged, broken, or seized drive pinion bearings Damaged, broken, and/or seized side bearings Damaged differential case Inferior gear oil Insufficient gear oil quantity | Replace Replenish |
Таблица в оригинале
Оригинальная страница руководства
