1984-Montero · rear axle a · страница 26 из 43 · Открыть оригинал PDF ↗
.(3) Measure the drive pinion preload (without the oil
seal). (Refer to p. 3-25.)
’ (4) If the drive pinion preload is not within the range of
the standard value, adjust the preload by replacing
either the drive pinion front shim(s) or the drive
pinion spacer.
NOTE
Select a thicker drive pinion spacer if necessary to avoid using
a large number of shims.
4. Remove the companion flange and drive pinion and drive
the pinion seal into place with the special tool. (Y11224)
5. Apply the specified multipurpose grease. to the oil seal
lip. :
Recommended multipurpose grease . . . . . . . . . . . .
S&E 53 lOa, N:LGI grade #2EP
6: Install the drive pinion assembly and companion flange’
with the mating marks properly aligned, and tighten the
companion flange self-@king nut to the specified torque
with the special tool (MB990850). (Refer to p. 3-23.)
NOTE .:
Apply’ a thin’ coat of specified multipurpose grease to the
surface of the washer that contacts the companion flange
before installing the drive pinion assembly.
7. Measure the drive pinion preload (with the oil. seal) to
verify that the drive pinion preload complies with the
standard value. (Refer to p. 3-25.)
Оригинальная страница руководства
