1984-Montero · rear axle a · страница 39 из 43 · Открыть оригинал PDF ↗
Inspection of Contact and Sliding Surfaces of Parts
-
1. Inspect the clutch plates and pressure rings.
(1) The friction surfaces of the friction plates, friction
discs, spring plates, and spring discs.
If there are any signs of seizure, severe friction, or
color change from heat, the locking performance
will be adversely affected. Replace the part with a
new one.
NOTE
The strong contact on the inner circumference of the friction
surfaces is because of the spring plate and the spring disc; this
wear is not abnormal.
(2) The six projections on the inner circumference of the
friction disc.
Nicks or dents will cause abnormalities in the clutch
pressure; if present, repair with an oil stone, or
replace the parts if necessary.
(3) The four projections on the outer circumference of
the friction disc.
Nicks and dents will cause abnormalities in the clutch
pressure; if present, repair with an oil stone, or
replace the parts if necessary.
(4) The friction- surface of the friction disc of the pres-
sure ring.
If there are nicks or scratches, repair by first grinding
with an oil stone and then polishing with rubbing
compound on a surface plate.
NOTE
The strong contact on the inner circumference of the friction
surface is because of the spring plate and the spring disc;
this wear is not abnormal.
Оригинальная страница руководства
