1984-Montero · rear axle a · страница 42 из 43 · Открыть оригинал PDF ↗
(4) Assemble the right and left friction plates, friction
discs, differential pinion shafts, and pressure rings,
and then measure the total width, as shown in the
illustration. Consider this to be “B”. (11 S665)
NOTE
Manually hold the V-shaped groove, squeeze the groove
together, and measure.
All parts should be dry.
(5) If the difference “S” between the depth “A” of the
differential case and the overall width “B:” obtained
previously plus the, spring, thickness is not within the
range of the standard value, replace the friction discs
to adjust.
S = A - (B + L1z + Lr)
NOTE
Be careful not to mix the types of clutch plates selected for
the right and left sides.
2. Make the adjustment as follows so that the dimensional
difference of the shaft direction of the differential
side gear while it is assembled into the differential case
agrees with the standard value.
(1) Measure depth of contact surfaces of differfential case.
Measure the depths of the thrust washer contact
surfaces of differential case A and B with calipers.
Assume these to be “C” and “D”.
(2) Assemble the pressure rings, the differential pinion
gears, the differential side gears, the differential
pinion shafts, and the thrust washers, and then
measure the distances from the backs of the pressure
rings to the ends of the thrust washers. Select thrust
washers so that the difference between the right and
left measured values is less than 0.05 mm (.002 in.).
NOTE
Measure with calipers while squeezing the V-shaped groove
manually.
Оригинальная страница руководства
